Denso BHT-200QW Especificações descarregar pdf (Página 110)

100

101

- 108 -

• Codabar（NW-7）（N）

[Syntax]

N [:[mini.no.digits [− max.no.digits]][startstop] [CD]]

The mini.no.digits and max.no.digits are the minimum and maximum numbers of barcode digits to be

read by the BHT, respectively.

These numbers must both be between 3 and 99 (inclusive) and satisfy the following

condition:

mini.no.digits ≤ max.no.digits

If both mini.no.digits and max.no.digits are omitted, the default reading range will be from the minimum

number of digits specified at system mode up to 99 digits.

If only max.no.digits is omitted, the BHT will only be able to read as many digits as specified

by mini.no.digits.

Start and stop are the start and stop characters, respectively. Specify each of these as A, B,

C, or D. If a question mark (?) is specified, it is treated as a wild card. The start and stop

characters are included in the number of digits. A to D are stored in the barcode buffer as a

to d.

CD is used to specify a check digit(s). If C is specified, barcodes are checked based on

MOD-10. The number of check digits is included in the number of digits to be read.

To specify multi-line code reading, first specify “&” and then specify this syntax as many

times as the number of rows to be read.

[Ex.] Reading 3 rows of a Codabar:

RdType = "&,N:8,N:6,N:4"

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 376 377

Comentários a estes Manuais

Sem comentários

Denso BHT-200QW Especificações Página 110

Comentários a estes Manuais

Manuais e produtos relacionados com Leitores de códigos de barras Denso BHT-200QW