Denso BHT-202Q Manual do Utilizador descarregar pdf (Página 109)

Barcode Handy Terminal



1. nu and then press the

NT key.

rrent setting.

Pres

to display the NETWORK ( creen for

Pr (DHCP) screen to

retur T

quired IP configuration is displayed when the IP

way is set to a value

the

Setting the DHCP

Select “3: DHCP” at the SET TCP/IP me

e SET DHCP screen displays as shown on the right. The highlighted

setting will be the cu

ess the Backspace/clear key to return to the SET TCP/IP menu.

s the dot key while holding down the SF key at the SET DHCP menu

DHCP) screen (acquisition check s

IP address at DHCP)

ess the Backspace/clear key at the NETWORK

n to the SE DHCP screen.

 Point  If the ac

address, subnet mask or default ga

other than “0.0.0.0”, the DHCP does not display on

screen shown on the right.

BS/C

key





+ [.] key

“1

Se imeo

The entry ran

econds.

 Point  Up to 32767 seconds can be entered, but in actual operation, a maximum of 190 seconds is

: TIMEOUT”:

ts the t ut for acquiring the IP config

uration from the DHCP server.

ge is from 00001 to 32767 s

available sinc

e the number of retries and retry intervals are determined by the system.

To set the DHCP:

(1) Press the ENT key.

to entry mode and the cursor displays, allowing the setting to be entered with the

aracter, press the Backspace/clear key. To delete the entire entry, press and hold

keys simultaneously.

ue, and then press the ENT key.

(2) The mode changes

numeric keys.

To delete a single ch

the Backspace/clear key or press the SF and Backspace/clear

(3) Enter the desired val

Press the Backspace/clear key to return to the SET FTP menu.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 197 198

Comentários a estes Manuais

Sem comentários

Denso BHT-202Q Manual do Utilizador Página 109

Comentários a estes Manuais

Manuais e produtos relacionados com Leitores de códigos de barras Denso BHT-202Q