Denso BHT-202Q Manual do Utilizador descarregar pdf (Página 27)

8. Battery Information

The battery information function provides the following information.

• Battery voltage (mV)

• Cradle installation status (charge status)

• Battery level

• Battery type

There are six battery levels.

The battery level is “HIGH” when fully charged and continues to drop to “MID” and then “LOW” and so on as

the BHT is used.

If a key is pressed or the touch panel is tapped when the battery level is “LOW”, the beeper will sound three

times and a ”Battery voltage low” message displays. This message will not display again until the BHT is next

suspended or resumed.

If use of the BHT is continued even when the battery voltage is low, the beeper will sound five times, a “Please

recharge battery.” message displays, and the BHT automatically goes into suspend mode. It will then not be

possible to resume the BHT until the battery has been sufficiently charged.

Level Voltage

HIGH 3.9 V or above

MID Less than 3.9 V

LOW Less than 3.7 V

WARNING Less than 3.6 V (Beeper sounds three times and message displays.)

CRITICAL Less than 3.5 V (Beeper sounds five times, message displays, and BHT

suspended automatically.)

NO_BATTERY No battery installed (BHT does not operate.)

The actual battery voltage may differ depending on how the BHT is used. Barcode reading and wireless

communication and so forth exert a large load on the battery and therefore the voltage level may display lower

than the actual level at such times. A message displays and the BHT switches to suspend mode at such times

also.

Ensure to always use a lithium-ion battery.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 406 407

Sem comentários

Denso BHT-202Q Manual do Utilizador Página 27