Denso BHT-825QW Manual do Utilizador descarregar pdf (Página 190)

175

2D Code Handy Terminal

5. Use the cursor keys ([▲] [▼]) or numeric key ([3]) to highlight the [3: NUM RESPONSES] and

then press the ENT key.

Entry mode is activated and the cursor is displayed.

6. Use the numeric keys to enter the desired value.

Set up the number of devices to detect.

This number is used only for the device detection ([1: DO IT] menu).

Valid Range: 0 – 8, Default: 0.

Detects a maximum of 8 devices when “0” is set.

Note that the setting specified here will not be saved.

To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold

the Backspace/clear key or press the SF and Backspace/clear keys simultaneously.

7. Press the ENT key.

8. Use the cursor keys ([▲] [▼]) or numeric key ([1]) to highlight the

[1: DO IT] and then press the ENT key.

The screen on the right is displayed and the device detection is started.

The device inquiry ends and the screen on the right is displayed

When;

・ The specified number of devices have been found.

・ The specified time has elapsed.

・ The Backspace/clear key has been pressed while detecting

devices.

Press the Backspace/clear key to return to the BROWSE DEVICE menu.

To set the detected device address as a destination remote device address

for the master station,

use the cursor keys ([▲] [▼]) or numeric keys to select the desired address

and then press the ENT key.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 252 253

Sem comentários

Denso BHT-825QW Manual do Utilizador Página 190