Denso AT21B-SM Manual do Utilizador descarregar pdf (Página 28)

7.1.3 Verification result output

(1) Report of match / mismatch status

You can select any of the following report types using the configuration software (ScannerSetting).

Selecting “Disable transmission” reports nothing.

Setting If there is a match: If there is a mismatch:

１

Disable transmission. Disable transmission.

２

Enable code data transmission. Enable code data transmission.

３

Enable OK transmission. Enable NG transmission.

(2) Beeper and indicator LED

You can check whether the verification result is a match or mismatch with the beeper and indicator LED.

When the beeper and indicator LED are enabled, they act as shown below.

Beeper Indicator LED

If there is a match: Emits a short beep. Lights in blue.

If there is a mismatch: Emits a long beep. Lights in red.

Output of the master data registered

Reading the “Output master data” barcode given below lets the scanner output the verification section of master

data entered in the data verification read procedure, together with the code ID mark.

“Output master data” barcode

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 108 109

Sem comentários

Denso AT21B-SM Manual do Utilizador Página 28