Denso AT21B-SM Manual do Utilizador descarregar pdf (Página 45)

8.3 Beeping, Indicator LEDs with scanner status

■ Normal operation

Status Beeping Indication LED

A read of a bar code is successfully complete

1 short beep

(Note 1) (Note 2)

Lights in blue

Barcode data read matches the master data in the n-point verification

scan mode

1 short beep

(Note 1) (Note 2)

Barcode data read matches the master data in the 2-point verification

scan mode

2 short beeps

Master data ragistration is successfully complete in the data

verification mode

1 short beep

(Note 1)

The scanner is ready to register master data in the data verification

mode

―

Lights in green

（always）

The “Start setting”, “End setting” or “Cancel” bar code is read from the

bar code menu

3 short beeps Flashes blue

Reading of parameter setting codes 1 short beep

(Note 1)

Lights in blue

Configuration software starts up or accepts new setting 3 short beeps × 2 Flashes blue

The scanner has read the “STRT” or “END” bar code out of

batch-process bar code symbols generated with the configuration

software.

3 short beeps

The scanner has read the “DATA1–8” barcode out of batch-process

barcode symbols generated with the configuration software.

1 short beep

(Note 1)

Lights in blue

Power activation

(Note 3)

4 short beeps ―

(Note1) The configuration software provides three choices for the beeping time of a short beep-60, 80

and120 ms.

(Note2) Beeps 70 ms× 2 times (140ms) when setting of the sound to complete reading is compound sound.

(Note3) Beeps if configuration software accept beeping for when the power is on. (Default not allowed)

power activation.

■ Error operation

Status Beeping

Indication

LED

Barcode data read does not match the master data in the data

verification mode.

Any codes apart from parameter setting code is read from the barcode

menu.

Three minutes have elapsed without reading any parameter setting

barcode after the barcode menu in the parameter setting procedudre.

Three minutes have elapsed without reading DATA after the scanner

has read the “START” barcode out of batch-process barcode symbols

generated with the configuration software.

A transmission error or timeout has occurred during communicaiton

with the configuration software.

Invalid control command is received.

A master barcode has the wrong numbr of digits during registration of

master data.

ACK response monitoring time (1 sec) have elapsed in ACK/NAK

mode.

A long beep

(480ms)

Trigger switch is pressed when trigger switch control is invalid. ―

Flashes red

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 108 109

Comentários a estes Manuais

Sem comentários

Denso AT21B-SM Manual do Utilizador Página 45

Comentários a estes Manuais

Manuais e produtos relacionados com Leitores de códigos de barras Denso AT21B-SM