Denso AT21B-SM Manual do Utilizador descarregar pdf (Página 44)

8.2 Indicator LED

The indicator LED lights or flashes in blue, green or red with scanner status.

（Refer to Section 8.3 for details of indicator LED in various states）

The indicator LED can be disabled with the Bar coded parameter menu or configuration software (Scanner

Setting).

In any of the following cases, however, the indicator LED comes on regardless of the current LED setting.

- When the scanner is being customized with the Bar coded parameter menu (Chapter 11),

- When the scanner receives an LED-ON command (LB, LG or LR) from the host computer

(refer to Appendix 2),

- When the configuration software (Scanner Setting) starts up or any setting is newly established,

- When the scanner reads a batch-process Barcode symbol,

- When the parameter values are saved by a PW command (refer to Appendix 2),

- When the scanner is in the scanner entry mode (refer to control command “E” in Appendix 2),

- When a master code is being registered or the registration is completed,

- When any error has occurred during registration of a master code,

- When the scanner has failed to save parameter values specified with the configuration software (Scanner

Setting), Bar coded parameter menu, or control commands,

- When the trigger switch is pressed when the trigger switch control is disabled,

- An error occurred in the hardware.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 108 109

Sem comentários

Denso AT21B-SM Manual do Utilizador Página 44